Dyna-Glo DGU732BDE User Manual (English)

Questions and Answers:

D
Daniel LeeJul 28, 2025
What to do if my Dyna-Glo Smoker has no heat?
- R
  Regina GarciaJul 28, 2025
  If your Dyna-Glo Smoker isn't producing heat, first, ensure the smoker is turned on. Then, check your circuit breaker and reset it if it has tripped. Also, check the outlet for a tripped GFI and reset or replace it if needed. If the breaker or GFI continues to trip, try a different outlet on a separate circuit. You can also test the outlet with another working appliance. If none of these steps work, the controller or heating element may need to be replaced.
P
Pamela DavisAug 1, 2025
Why my Dyna-Glo Smoker is not getting hot enough?
- M
  Mark DavisAug 1, 2025
  If your Dyna-Glo Smoker isn't generating enough heat, make sure you pre-heat it for 15-20 minutes and increase the temperature settings using the controller. Ensure the door is closed and latched properly. Also, verify that you are using an extension cord rated for outdoor use at 15 amps.
E
Eric McbrideAug 6, 2025
What to do if my Dyna-Glo Smoker isn't producing enough smoke?
- R
  Rachel RodriguezAug 6, 2025
  If your Dyna-Glo Smoker isn't producing enough smoke, check the wood chip level; the box should be at least 3/4 full. For proper smoke generation, the wood chips should be 1 to 3 inches long and no thicker than 1/4 inch. Wood shavings and chunks are not recommended, and do not use charcoal.
X
xwilliamsAug 11, 2025
Why does my Dyna-Glo Smoker keep tripping the circuit breaker?
- S
  steven26Aug 11, 2025
  Your Dyna-Glo Smoker might be tripping the circuit breaker because another appliance is using the same circuit, drawing too much power. Moisture in the controller, cord, or outlet connections, a damaged cord, or a damaged electrical connection could also be the cause. Try using a different outlet on a separate circuit. Ensure all connections are dry and free from moisture, and avoid using the smoker in the rain or snow. Inspect the cord for damage and replace it if necessary. If the problem persists, the controller may need replacement.
W
William HoganAug 16, 2025
How to prevent flare-ups in my Dyna-Glo Smoker?
- J
  Jeff DownsAug 16, 2025
  To prevent flare-ups in your Dyna-Glo Smokers, trim excess fat from the meat before cooking. Also, ensure that the cooking temperature is not set too high. Lastly, regularly clean your smoker according to the provided instructions to prevent grease build-up.
A
alison73Aug 21, 2025
What to do for a persistent grease fire in my Dyna-Glo Smoker?
- D
  Douglas DavisAug 21, 2025
  If you have a persistent grease fire in your Dyna-Glo Smoker, turn off the smoker and open the door to let the fire burn out. Do not use water to extinguish the fire, as personal injury may result. Allow the smoker to cool completely before cleaning the grease drip tray and cup.

Dyna-Glo DGU732BDE Specifications

General

Brand	Dyna-Glo
Model	DGU732BDE
Category	Smokers
Cooking Area	732 square inches
Number of Cooking Grates	4
Material	Steel
Temperature Gauge	Yes
Fuel Type	Charcoal
Adjustable Shelves	Yes
Finish	Black
Warranty	1 Year Limited
Type	Vertical Smoker