10
ASSEMBLY INSTRUCTIONS
1. Remove the pre-installed screws on the bottom of
the cabinet assembly (A). Attach each of the rear
casters (B) to the bottom of the cabinet assembly
(A) using 4 M5 x 12 (CC) screws per caster. Attach
the bottom of the front legs (C) to the bottom of the
cabinet assembly (A) using 3 M6 x 12 (BB) screws
per leg.
2. CAUTION: This unit is HEAVY! Do not attempt
this step without assistance!
With the assistance of a helper, stand the smoker
upright on a rm and level surface. (Make sure
that legs and casters are rmly attached). Remove
the pre-installed screws on the back of the cabinet
assembly (A) and attach the rear handle (D) using
the pre-installed screws.
1
2
D
A
C
Hardware Used
BB
M6 x 12 mm
Screw
x 6
BB
B
CC
M5 x 12 mm
Screw
x 8
A
BB
DD
Hardware Used
CC
M5 x 12 mm
Screw
x 4
CC
To Next Page
Loading...
