DYNACO DYNALOGIX II DY 4000 - Setting Door Limits; Setting Limits on Initial Power-up

W
Dff{mo
@
2.0
A
DY 4000
Setting
Limits
Confirm all electrical connections are
properly
wired and terminated before
power
up.
Reference: Wiring Diagram that came
with
DYNAGO Door.
Setting
Limits
on
Initial
Power-up
Automatic activation's should be disconnected
prior
to setting
limits. lf connected
door may activate and injury or damage
may
occur.
1. On initial
power
up the DY4000
will
blink SET
LIMITS on the
display.
2. Press and hold both PROGRAM buttons until display changes to
Password.
After display changes,
release
buttons.
See figure: 2.0-1.
Press and
hold
PROGRAM
button until
display
changes to:
Figure 2.0-1: Entering
Program Mode
3. Press and release the red arrow buttons to scroll to 562.
Note: On initial start up the
Password screen will be bypassed, and will
directly enter
the LimitSet screen.
Note: Password number will be stored for 4 minutes after
initially
entering.
Entering
program
mode during this time will not
require
reentry
of
oassword number.
4. Press
and release the
Enter button. Display should change to: LimitSet.
See figure 2.0-2.
Press and
release
the
Enter button.
Display
should
change to:
Figure 2.0-2: Enter Button
@-#i'@r
@
A
oPEN cLosEl
| -
3DYNACO
USA,
INC,
?tp
^4ea*r caDaaz
Sa/oft4
&Dea,ey