Dynacord PSX 1250 User Manual

MONITOR
MONITOR
MCMTCR
BREW
RET
28. M O N I TOR BREAK RET/SEND
These jacks are used for looping in an equalizer etc. into the monitor signal path. The return
jack RET interrupts the bus signal. The SEND jack can also be used as an output e.g. for
additional monitor power amps.
SEND *
MONITOR EO
MONITOR
29. E QUALIZING .
The EQ section allows for a very comprehensive and effective control of the monitor signal for
different frequency regions. Turning the control to the right increases the respective frequency
region. Turning left will decrease the respective frequency region.
When adjusting you should always start at a neutral position, i.e. all controls are in central
position. If possible, do not use extreme control positions; normally a small sound correction
is enough and delivers the best sound quality. Take as orientation the naturalness of the
reproduction and depend on your musical trained ear for sound checking. You can effectively
avoid acoustical feedback by operating of the mid control (MID) gently. Avoid too much gain
especially in this frequency region, a slight lowering allows an amplification of microphone
signals with little danger of feedback.
30. M O N ITOR
Volume control for the monitor bus output and monitor power amplifier.
For further information see : 57, Speaker Output Monitor

Dynacord PSX 1250 Specifications

General

Brand	Dynacord
Model	PSX 1250
Category	Music Mixer
Language	English