Dynacord PSX 1250 User Manual

TAPE
TAPE
TAPE
PLAYBACK
L ( §) 0-—23
®
— 24
SO
23. TAPE PLAYBACK
You can playback a tape or cassette recording via these sockets. The volume
is controlled by the TAPE RET control (27) and does not depend on the position
of the master faders (22).
LETT
•
IVHT M94TO?
□
•a £6
□
•a dB
0
D
O «*
□
o «
G
0
o <a
□
o i a
D
0
-a «*
0
-a cs
0
0
-a o
D
-a cs
□
D
-a cH
D
-a d>
D
□
-o m
D
-c <s
D
0
■ t « a
D
-* <B
0
D
-it
0
■ ia c£
D
0
-21 <£
D
-21 «
D
D
- TO -
0
- TO -
0
D
— ausv —
□
— 9J9t -
0
G
ffCCESKK Ch
D
pxrcssai tx
D
DYNAMIC SONAL PROCESSING
24. TAPE SEND
From these sockets you can take the master bus signal for tape recording.
The recording level is controlled by the TAPE SEND control (25) and does not
depend on the position of the master faders (22).
25. TAPE SEND control
With this stereo control knob you can control the output signal of the TAPE
SEND sockets (24). This control is for driving a connected tape recorder or
cassette player.
26. TAPE to MON
With this control you can add the TAPE signal to the MONITOR section. The
volume does not depend on the position of the RET controls (27).
(Very useful for playback performances)
27. TAPE RET control
These stereo controls adjust the volume of the tape playback. This tape signal
is fed in behind the Master L + R faders (22) and therefore does not depend
on the position of the MASTER L + R faders (22).
You can play back tape signals at any volume without altering the master
volume by the master faders (22).

Dynacord PSX 1250 Specifications

General

Brand	Dynacord
Model	PSX 1250
Category	Music Mixer
Language	English