Dynalink AXE10200 - Page 66

CHAPTER 6 - SPECIFY YOUR MESH Wi-Fi ROUTER SETTINGS
62
PPTP Server
Enable VPN Server
Enable or disable the VPN Server.
VPN Details
Select General or Advanced settings.
Username and Password
Select General and click the Add Rule button. Input the username and password to authenticate the devices to
the VPN server. Then click the Save button.
Advanced Settings
Authorization Mode
Select Auto, MS-CHAPv1, or MS-CHAPv2.
MPPE Encryption
Select the MPPE Encryption type “MPPE-128, MPPE-40, or No Encryption”.
Connect to DNS Server
Automatically
Select Yes or No to connect to the DNS Server automatically.
Connect to WINS Server
Automatically
Select Yes or No to connect to the WINS Server automatically.
MRU
The Maximum Receive Unit (MRU) sizes are sent to the client as part of the PPTP parameters to use during the
PPTP session. We recommend that you do not change the MRU values. The incorrect MRU values cause the
traffic through the PPTP VPN to fail.
MTU
The Maximum Transmission Unit (MTU) sizes are sent to the client as part of the PPTP parameters to use during
the PPTP session. We recommend that you do not change the MTU values. The incorrect MTU values cause the
traffic through the PPTP VPN to fail.
Client IP Address
The IP address range of PPTP clients.