To Next PageTo Next PageWhat to do if the Dynascan Monitor remote control does not work?
If the Dynascan Monitor's remote control isn't working, first, ensure there are batteries inside. Then, verify the batteries are fresh and correctly oriented. Make sure you're within the remote's operational range. Also, bright light from special fluorescent or neon lights can interfere with the remote; avoid using it near these.
How to fix a Dynascan Monitor when no image is displayed?
If no image is displayed on your Dynascan Monitor, verify that the DVI in cable is securely plugged in. Also, check that the main switch is in the ON position and the power cord is fully connected. Ensure the image source resolution is set to 1920 × 1080 (1080p). Finally, inspect the DVI cable for any damage or excessive bending.
Why is the Dynascan DS55LX3 auto on/off not working?
If the auto on/off function of your Dynascan Monitor isn't working correctly, check that the TIMER setting in the menu is not set to 'OFF'. Also, verify that the 'Power On Time' and 'Power Off Time' settings are configured accurately.
General| Screen Size | 55 inches |
|---|---|
| Response Time | 8 ms |
| Aspect Ratio | 16:9 |
| Refresh Rate | 60 Hz |
| Resolution | 1920 x 1080 pixels |
| Viewing Angle | 178°/178° |
| Connectivity | HDMI, VGA, USB |
| Display Type | LED |
| Input Ports | HDMI, VGA |
