What to do if the remote control of my Dynascan DS421LT4 Monitor does not work?
If the remote control for your Dynascan Monitor isn't working, verify that batteries are installed and have correct polarity. Ensure the batteries are fresh. Make sure the remote is within operational range. Strong light sources, such as fluorescent or neon lights, might interfere with the remote; avoid using it near such lights.
How to fix a Dynascan DS421LT4 when no image is displayed?
If your Dynascan Monitor displays no image, ensure the DVI cable is fully plugged in and not damaged. Check that the main switch is ON and the power cord is properly connected. Also, verify the image source resolution is set to 1920 ? 1080 (1080p).
Why does my Dynascan DS421LT4 Monitor turn on/off automatically?
If the auto on/off function of your Dynascan Monitor isn't working correctly, check that the TIMER setting in the menu is not set to “OFF”. Also, verify that the “Power On Time” and “Power Off Time” settings are configured correctly.
What to do if nothing happens when switching on Dynascan Monitor?
If nothing happens when you switch on the main switch of your Dynascan Monitor, unplug the power cord from the socket. After a few seconds, plug it back in to reset the device. Note that unplugging the power cord will not change the settings.
Why is the image on my Dynascan DS421LT4 unstable?
If the image on your Dynascan Monitor is unstable, check that the DVI in cable is completely plugged in.
To Next Page
General
