What to do if my Dynascan DI651ST2 Monitor displays no image?
If your Dynascan Monitor isn't displaying an image, start by checking that the cable is fully plugged in and is not damaged or bent excessively. Also, make sure the main power switch is in the ON position and the power cord is properly connected. Verify that the image source resolution is set to a supported format.
How to fix a Dynascan DI651ST2 remote control that is not working?
If the Dynascan Monitor remote control isn't working, first verify that batteries are installed with correct polarity. Then, check the batteries to ensure they are fresh. Make sure you are within the remote's operating range and avoid using the remote near bright or special fluorescent lights or neon lights, as these may interfere with the signal.
What to do if nothing happens when switching on the Dynascan DI651ST2?
If nothing happens when you switch on the Dynascan Monitor, unplug the power cord from the socket. Wait a few seconds, and then plug it back in to reset the signage.
How to troubleshoot auto on/off not working on Dynascan DI651ST2 Monitor?
If the auto on/off function on your Dynascan Monitor isn't working correctly, check that the TIMER setting in the menu is not set to “OFF.” Also, verify that the “Power On Time” and “Power Off Time” settings are configured accurately.
To Next Page
General
