EasyManua.ls Logo

Dynascan DS2 DS322LR4-1 - User Manual

Dynascan DS2 DS322LR4-1
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
User Manual
Version 2.00
The use of diagrams and illustrations in the manual are for reference only. The actual product may be different.
Product design and specifications are subject to change without notice
Professional LCDs

Table of Contents

Questions and Answers

  • T
    Timothy PetersAug 2, 2025
    What to do if Dynascan DS2 DS322LR4-1 Monitor shows no image?
    • T
      Tracy RomeroAug 2, 2025
      If your Dynascan Monitor isn't displaying an image, try these steps: First, ensure the DVI or HDMI cable is fully plugged in. Next, check that the main switch is ON and the power cord is securely connected. Also, verify that the image source resolution is set to 1920 × 1080 (1080p). Inspect the DVI or HDMI cable for damage or excessive bending. Finally, confirm that the correct input is selected and the cord to and from the player device is properly connected.
  • M
    Matthew NguyenAug 13, 2025
    Why does Dynascan Monitor remote control not work?
    • J
      Jill JohnsonAug 13, 2025
      If the remote control for your Dynascan Monitor isn't working, try the following: * Check if batteries are inserted in the remote. * Verify the batteries are fresh and correctly oriented. * Ensure the remote is within its operational range. Also, bright light sources, such as special fluorescent or neon lights, may interfere with the remote's operation.
  • L
    Lucas HowardAug 21, 2025
    What to do if nothing happens when switching on Dynascan DS2 DS322LR4-1 Monitor?
    • A
      alinicholasAug 21, 2025
      If nothing happens when you switch on the main switch of your Dynascan Monitor, unplug the power cord from the socket and plug it back in after a few seconds to reset the signage. Note that unplugging the power cord will not change the settings.

Summary

Safety Precautions

Important Safety Information

Getting Started

Installing and Replacing Remote Control Batteries

Installation

Mounting

Connecting to a Power Source

Connecting an External Video Source

Operating Instructions

Powering On;Off the Display

Press the power switch on the back of the display to turn it on or off. Remote control only works when power is ON.

Using the Remote Control

Aim the remote at the IR receiver on the display. Operating range is 2.5 meters. Avoid ambient light interference.

Navigating the On Screen Display (OSD) Menu

Specifications

Troubleshooting

Dynascan DS2 DS322LR4-1 Specifications

General IconGeneral
Screen Size32 inches
Resolution1920 x 1080
Aspect Ratio16:9
Refresh Rate60 Hz
Response Time8 ms
Brightness250 cd/m²
Contrast Ratio1000:1
Viewing Angle178° / 178°
Input PortsHDMI

Related product manuals