Page | 5
BEFORE GETTING STARTED
Installation must conform to the following:
Local, state and national codes, laws, regulations and ordinances.
National Fuel Gas Code, ANSI Z223.1 latest version.
National Electric Code, ANSI/NFPA-70 latest revision.
Standard for Controls and Safety Devices for Automatically Fired Boilers, ANSI/ASME CSD-1 latest
revision, when required.
Read this manual in its entirety before attempting installation, start-up or service.
Proper operation depends on following all instructions carefully, including those contained within the
manufacturers’ components that are provided with your boiler.
This boiler contains extremely hot water under pressure and failure to follow all instructions could cause
personal injury, property damage or death.
Dynatherm™ boilers must be installed, serviced, maintained, repaired, upgraded and/or modified only by
a qualified Dynatherm™ installer/technician.
A qualified Dynatherm™ installer/technician is an individual who has been properly trained on installing
and servicing Dynatherm™ boilers and must be a licensed installer.
Homeowners should never attempt to install, service, repair, upgrade or modify the Dynatherm™ boiler.
Dynatherm™ boilers must be installed by a qualified installer/technician in order to validate the warranty.
Verify you have the correct size boiler for your home and/or application. Refer to the DOE & IBR ratings
chart found in the FP Series Boiler Specification section of this this manual.
This boiler requires regular yearly maintenance and service to operate properly and safely.
To Next Page
Loading...