P25P24
Owner's Manual Contour Running-in
Running-in
Running-in the loudspeakers
The moving parts of a newly manufactured
Dynaudio loudspeaker have been
acoustically checked after production,
but nevertheless are not as exible as
they need to be for optimum results to
be realized. The higher the quality of any
driver system, the more demanding the
loudspeaker will be regarding time for
running-in the system.
A newly unpacked Dynaudio loudspeaker
therefore requires several weeks running/
playing to reach its optimum performance
capability. After that period, a couple of
minutes before every listening session will
be helpful to “warm up” the loudspeakers.
Power rating
Due to the construction and the driver
technology Dynaudio loudspeakers can be
driven with very high power levels. With a
high quality amplier, delivering undistorted
signals, the speaker can achieve high
levels without any compromises in sound
quality.
Attention must be given to ampliers
with very low power and adjustable tone
controls or switches. These types may
soon overreach their own performance
limits and may send distorted output
signals to the speakers, compromising
even high quality technology.
Distorted output signals
Distorted output signals from too weak,
defective or overloaded ampliers may
damage the loudspeakers.
Use high quality ampliers only and
run loudspeakers and ampliers within
specied power ratings.
Any damage caused under such
circumstances is not covered by the
Dynaudio warranty and is easily avoided in
the rst place by consulting your Dynaudio
dealer for advice regarding the choice of
amplier.
To Next Page
Loading...
Need help?
General
