Dynaudio Sub 6 Owner's Manual

14 15
Unpacking
1 2 3
transport damage. Transport damage
may be expected if the packaging is
severely marked. Do not attempt to
install the subwoofer if it is damaged. If
the contents are incomplete or damaged,
please contact your Dynaudio retailer or
local distributor. Distributor addresses
can be found at: dynaudio.com.
Packaging material
The packaging has been designed
so that it may be reused if it was not
damaged during initial transport. Keep
the packaging and use it for all further
transport.
Note
The Sub6 is heavy and is best
unpacked close to its installed
location by two people working
together.
1. Open the carton from the top and
remove the subwoofer accessories.
Do not remove the upper element of
the internal packaging.
2. Carefully rotate the carton on to its
side and again to turn it upside-
down.
3. The carton can now be lifted away
from the subwoofer. Remove the
lower internal packaging now on
top to reveal the underside of the
subwoofer.
4. Open the plastic bag and remove
it from around the base of the
subwoofer.
5. Carefully rotate the subwoofer onto
its side and again to turn it onto its
feet. The internal packaging can now
be removed followed by the plastic
bag.
After unpacking, make sure the
components are complete and check
the subwoofer and all accessories for
Unpacking

Dynaudio Sub 6 Specifications

General

Subwoofer type	Active subwoofer
Number of subwoofers	2
Subwoofer peak power	500 W
Subwoofer driver diameter	240 mm
Subwoofer frequency range	16 - 230 Hz
On/off switch	Yes
Product color	Black
Speaker enclosure	Closed
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W

Weight and Dimensions

Subwoofer depth	268 mm
Subwoofer width	447 mm
Subwoofer height	300 mm
Subwoofer weight	21500 g