TunerFirmwareUpdateProcessforDynexModelDX‐32L150A11
1. IMPORTANT: Please completely read these instructions prior to starting your
update process.
2. Determine the proper Rev id by looking at the sticker on the side of the TV (see photo
below) and write down the Model and Rev id for use later in this process.
3. Insert USB drive to your PC or Mac
4. USB drive being used must not have any folders or additional files on the device.
5. Download the firmware that matches the Model and Rev id of your TV.
6. To download firmware click on the “Support/Downloads” tab; then locate the
corresponding Rev id of your TV.
7. Click on the firmware link titled “LC32KS70CMO.Bin”(Some maybe LC32KS70
AUO.Bin) when the pop up box appears select “Save” and choose the destination of
your USB drive.
a. Note: Do NOT change the name of the file.
b. Note: This file is <5 Megs in size; download time should be less than 1 minute.
8. Once down load is complete safely remove your USB drive.
9. Disconnect the AC power from your wall outlet for the TV
10. Insert USB device into the SERVICE PORT; located in one of 3 places, back, side or
bottom. The correct port will be labeled either Service or Service/USB. See photo below
To Next Page
Need help?
General