Dynojet Power commander 3 - Preparation and Component Removal; Connecting the Power Commander Wiring

3 Remove the panel shown in Figure B.
4 Install the PCIII next to the battery
(Fig. C).
5 Attach the ground wire of the PCIII to
the negative side of the battery.
Fig. A
Fig. BFig. C
PCIII
Remove
1 Remove the bodywork panels shown
in Figure A.
2 Remove the front fairing panel to
access the battery.
2008 Yamaha Tmax 500 - PCIII USB - 2i437-411 www.powercommander.com
Remove