Dynojet Power commander V - Ignition Coil and Front O2 Sensor Wiring; PCV to Ignition Coil Connection; O2 Optimizer to Front Sensor

I11-009 www.powercommander.com 2012 Arctic Cat 1100 Turbo PCV - 7
21 Attach the TPS connector from the PCV harness to the stock TPS connectors.
22 Locate the MAP sensor connector.
The MAP sensor connector is located on the
manifold slightly rearward of the TPS connector.
23 Using the supplied posi-tap, attach the grey/white
wire from the PCV harness to the green/tan wire
on the stock MAP sensor.
24 Route the last leg of the PCV harness up and over the intake manifold to the
right hand side of the snowmobile.
25 Unplug the 2-pin crank sensor connector.
This connector is located inward of the exhaust silencer along the engine.
FIG.O
FIG.N
FIG.M