Dynojet Power commander V - Grounding and Crank Sensor Connection; Ground Wire Attachment; Crank Position Sensor Connection

I11-009 www.powercommander.com 2012 Arctic Cat 1100 Turbo PCV - 6
14 Attach the injector connector from the PCV harness to the stock injector
connectors as shown in Figure J.
Verify these connections are pushed down amongst the stock harness so the
side panel cooling vent can be slid over the top into its factory location.
15 Remove the fuse box cover on top of the clutch guard. This allows access to
the nut shown in Figure K.
16 Remove the nut.
17 Attach the ground lug from the PCV harness to the bolt.
18 Retighten the nut.
19 Route the other leg of the of the harness upward near the intake manifold.
20 Locate and unplug the TPS sensor.
FIG.L
FIG.K
FIG.J