I11-009 www.powercommander.com 2012 Arctic Cat 1100 Turbo PCV - 5
9 Pull rearward on the cowling allowing the tank shroud to pop loose above it.
10 Lift the tank shroud off the gas filler neck taking care to unplug the spade
connectors for the reverse beeper.
11 Using the supplied velcro, secure the PCV to the top of the stock ECU as
shown in Figure H.
Make sure to clean both surfaces with the alcohol swab before attaching.
12 Allowing the wire harness to loop rearward on the machine and then come
forward, route the injector leg of the harness down the left side of the engine
on top of the clutch guard as shown in Figure H.
13 Locate and unplug the 6-pin connector on top of the clutch guard as shown in
Figure I.
FIG.G
FIG.H
FIG.I
PCV harness
To Next Page
Loading...
