Dynojet Power commander V - Ignition Coil and Front O2 Sensor Wiring; PCV to Ignition Coil Connection; O2 Optimizer to Front Sensor

I25-010 www.powercommander.com Can-Am Spyder 2011-2013 RT/RTS & 2013-2014 RS/ST - PCV F/I - 7
21 Unplug the stock wiring harness from the Ignition Coil and plug the pair of
PCV connectors with GREEN and BLUE colored wires in-line of the Ignition
Coil and stock wiring harness (Fig. N).
This connection is located on the left side near the oil tank. The connector is
on the front of the coil, squeeze the tab and pull forward to release.
22 Reinstall all of the bodywork.
FIG.N
Ign Coil