Dynojet Power commander V - Grounding and Crank Sensor Connection; Ground Wire Attachment; Crank Position Sensor Connection

I25-010 www.powercommander.com Can-Am Spyder 2011-2013 RT/RTS & 2013-2014 RS/ST - PCV F/I - 6
18 Attach the ground wire of the PCV with the small ring lug to the rear cylinder
head on the left side (Fig. K).
Remove the stock bolt and insert bolt thru the eyelet of the PCV ground wire and
reinstall bolt into head.
FIG.K
FIG.M
20 Plug the mating connectors from the PCV in-line of the stock Crank Position
Sensor connectors (Fig. M).
FIG.L
19 Locate the stock Crank Position Sensor connectors and unplug them (Fig. L).
This is a BLACK 2-pin connector pair on the left side of the engine.
PCV
PCV
Stk
Stk
Ground
Unplug