I25-010 www.powercommander.com Can-Am Spyder 2011-2013 RT/RTS & 2013-2014 RS/ST - PCV F/I - 5
12 Plug the pair of PCV leads with YELLOW colored wires in-line of the stock
wiring harness and the rear fuel injector (Fig. G).
13 Reinstall the MAP sensor to throttle body.
14 Unplug the stock wiring harness from the front fuel injector on the right hand
side (Fig. H).
This connection is located to the right rear of the air box.
15 Plug the pair of PCV leads with ORANGE colored wires in-line of the stock
wiring harness and front fuel injector.
16 Locate the Throttle Position Sensor on the left side
of the throttle bodies.
17 Use the supplied Posi-tap to attach the GREY wire
of the PCV to the stock TAN/WHITE wire of the
TPS wiring harness.
Figure J is shown with the TPS harness disconnected
from the sensor. Make sure to reconnect the harness
to the sensor after attaching the GREY wire to it.
FIG.G
FIG.H
FIG.J
Posi-tap
TPS
Unplug
To Next Page
Loading...
