Dynojet Power commander V - PCV and O2 Optimizer Installation; Mounting PCV and O2 Optimizer; Harness Routing; Injector Access and Disconnection

I25-010 www.powercommander.com Can-Am Spyder 2011-2013 RT/RTS & 2013-2014 RS/ST - PCV F/I - 4
8 Using the supplied Velcro, secure the PCV unit in place under the seat.
9 Route the PCV harness down the left side of the vehicle and go towards the
throttle bodies.
FIG.D
10 Remove the mounting bolt for the stock MAP sensor on the left side of the
throttle bodies.
This allows access to the rear fuel injector.
FIG.E
11 Unplug the stock wiring harness from the rear fuel injector (Fig. F).
FIG.F
Remove
Unplug