Dynojet Power commander V - Grounding and Crank Sensor Connection; Ground Wire Attachment; Crank Position Sensor Connection

25-004 www.powercommander.com 09-11 CanAm Spyder PCV - 6
13 Attach the ground wire of the PCV to the rear cylinder head on the left side
(Fig. K).
Remove the stock bolt and insert bolt thru the eyelet of the PCV ground wire and
reinstall bolt into head.
FIG.K
15 Unplug the stock wiring harness from the O2 sensor (Fig. M).
This connection is located near the battery box. The inner tail section will need to
be removed to access this connection.
FIG.M
14 Reinstall the air box. Use the supplied zip ties to secure the PCV harness
along with the stock harness in the original location.
FIG.L