Dynojet Power commander V - Ignition Coil and Front O2 Sensor Wiring; PCV to Ignition Coil Connection; O2 Optimizer to Front Sensor

25-004 www.powercommander.com 09-11 CanAm Spyder PCV - 7
The O2 optimizer for this model controls the stock closed loop area. This area
is represented by the highlighted cells shown in Figure O. The optimizer is
designed to achieve a target AFR of 13.6:1. To use this optimizer you must
retain your stock O2 sensor.
It is not recommended to alter the values in the highlighted area unless
instructed to do so by a Dynojet technician.
If using the Auto tune system do NOT input values in this area in your Target
AFR table.
FIG.O
16 Plug the O2 optimizer in-line of the stock wiring harness and O2 sensor.
17 Secure the O2 optimizer the backside of the battery using the supplied velcro.
18 Reinstall all bodywork.
FIG.N