7
INSTALLING THE POWER CORE SOFTWARE
USING THE POWER VISION UPDATE CLIENT
This stand alone application will launch the Update Client
allowing you to update your Power Vision with the latest
fi rmware, retrieve additional tunes, or restore the Power Vision to
the original Dynojet factory settings.
1 Connect the Power Vision to your computer using the included
USB cable.
2 Navigate to the POWERVISION drive attached to your computer
and run the Update.exe fi le.
3 Click Update to load the current fi rmware. If the Update button is
grayed out, your Power Vision already has the latest fi rmware.
4 Click Restore to reload all original Dynojet tune and stock fi les.
5 Click Get Tunes to open the Dynojet Tune Finder. Follow the
instructions to Upload your PV_Info.txt fi le and retrieve new tunes.
6 Click Manual Firmware Update to navigate to and load a version
of fi rmware already saved on your computer.
Firmware Version: 4.12.8299.20956 S/N: PV00073231
Help
1.0.3.0
Manual Firmware Update
Restore
Get Tunes
Download the Power Core software and take tuning to a
whole new level.
Note: Downloading the Power Core software is optional
and not necessary to use the Power Vision.
1 Go to www.dynojet.com.
2
From the top navigation menu, select Support>Downloads.
3 Click Power Vision 3.
4 Click the Software drop-down and download the Dynojet
Power Core software.
5 Double-click the saved fi le to begin installation. Follow
the on-screen prompts. Refer to the Power Core Help for
more information.
To Previous Page
Loading...
Need help?
General
