Using Your D3
D3 Pilot’s Guide 5-3
CHARGE USING THE AC POWER ADAPTER OR VEHICLE POWER ADAPTER
• Plug the AC Power Adapter into a standard wall plug, or the Vehicle Power Adapter into a
vehicle DC socket. The Vehicle Power Adapter is designed to work in cars, 14V aircraft, and 28V
aircraft.
• Connect the Power Adapter to the USB-C port on the left side of the D3.
• Leave connected for approximately 6 hours to completely charge from empty (with a USB-C
power source that can supply 1.5 amps or more). Less time will be needed if the battery is
partially charged.
• When powered on, a full charge is indicated by a full battery gauge on the display.
• To charge the D3 faster, turn the unit off after power is connected. A red indicator light on the
power button illuminates to indicate charging is in progress. The light turns green when the D3
is fully charged.
•
ADJUSTING SETTINGS AND PREFERENCES
You can adjust settings such as ground speed units (KTS / MPH / KPH), altitude units (feet /
meters), whether the D3 automatically shuts down after a period of inactivity, and other display
settings. To adjust settings on your D3:
• Touch the Menu icon in the upper left corner of the display.
• Touch “Settings” to enter the settings menu.
• When you are finished, touch anywhere outside the settings menu to completely exit the menu
system. You may also use the “back” arrow to navigate back to other settings.
• Other preferences, such as brightness control and a toggle for synthetic vision, can be found in
the Main Menu.
To Next Page
Loading...
