Using Your D3
5-2 D3 Pilot’s Guide
Before First Use
Before you use your D3 for the first time, please complete the following initial setup and
configuration steps:
• Fully charge the battery (see following section).
• Check for D3 software updates at www.dynonavionics.com.
• Choose settings (see following section).
Turn the D3 On and Off
Turn the D3 on and off by holding the power button on the top of the device for about two
seconds. The D3 will also automatically power on any time an external power source is connected.
Turn the D3 off by pressing and holding the power button for three seconds.
Charging the Battery
BATTERY INFORMATION
The D3 is powered by an internal Li-Ion battery that provides at least 5.5 hours of use from full
charge when not connected to an external power source. The amount of time that the battery will
operate the D3 from a full charge will vary with temperature, GPS visibility, use of the external
GPS antenna, and the brightness setting. You can decrease the brightness and disable synthetic
vision to maximize battery life.
To Next Page
Loading...
