Emptying your bin
Empty your bin as soon as the dirt reaches the MAX level
Remove your bin
Release the dirt
Close the bin
Cleaning your bin
Minimise dust contact
Push the bin base upwards until your bin and bin base click into place.
Push your bin back into place, make sure it clicks securely back into your robot.
Hold your bin over a rubbish container, pointing downwards.
Push the cyclone release button on the handle.
Your bin will slide down, cleaning the shroud as it goes, the bin base will
open, releasing the dirt.
Cover your bin tightly in a dustproof bag while you empty. Remove your bin
carefully, seal the bag tightly and dispose.
Press the bin removal catch on the top of your robot and lift your bin away.
Use the handle to carry your bin.
Your bin isn’t dishwasher safe and using detergents, polishes or air
fresheners to clean it isn’t recommended, as it could damage your robot.
Empty your bin and press the bin empty catch. This is located under the
cyclone, on the bin runner.
Slide your bin off the runner and put the cyclone to one side.
Only use a damp, lint-free cloth to clean your bin.
Make sure that your bin and seals are completely dry before replacing.
Push bin back into
place at the rear of
your machine until you
hear a click
With the handle lifted,
the cyclone release
button is located in the
middle of the handle.
The bin removal catch is
located behind the screen on
the top of the robot. This can
be pressed and the bin pulled
away from the main body.
To Next Page
Loading...
