Cleaning your camera lens and sensors
To maintain optimum performance, regularly check and clean dust,
debris and smears on the sensors.
We recommend that you check and clean your robot’s sensors at least once
a month.
Use a soft, dry, lint-free cloth to wipe the top sensors and camera lens. Do not
use cleaning fluids, liquids or sprays of any kind. Turn your robot over and
place on a soft surface. Use the same cloth to wipe the sensors on the bottom
of the machine.
For more information and support videos for your machine go online:
www.dyson.com/support
Locate seven sensors on the base of the machine. Two sensors
on either side towards the rear. Two are located on the front
corners. One sensor is located in the recess in front of the right
wheel.
Locate seven sensors. The first pair are at the sides
of the robot near to the front and top of the machine.
The second pair are at the front of the robot, either
side of the brush bar. The third pair are immediately
in front of the second pair facing forwards. The final
sensor is the LED light ring and camera on top of the
robot in front of the LCD touchscreen.”
To Next Page
Loading...
