Dyson supersonic HD08 - Operating the Dyson Supersonic; Controls and Indicators; Diagnostic LED Warnings

9
supersonic
Temperature control
4 precise heat settings, including a cold
setting to fix a style:
High
Medium
Low/scalp mode
No red LED - Constant cold or cold
shot button pressed.
Cold shot
Press and hold to deactivate heat and
set style.
Operating
Airflow control
3 precise settings:
Fast
Medium
Gentle
Power on/off
Slide the switch to the
on or off position.
The LEDs will flash continually to communicate one of the following warnings:
Diagnostic LEDs
LEDs
When solid, the LED lights indicate which
settings you’re using.
The air exit and metal ring may be hot during use. Allow to cool before handling.
Three red LEDs flashing:
Clean filter if not resolved contact call centre. See the Helpline section
for details.
Three white LEDs flashing:
Clean filter. See the Helpline section for details.