5. Wick thin CA into the joint between the
wing and fuselage. Make sure to apply CA
to left, right, top and bottom to guarantee the
wing is glued securely.
Note: Avoid using a CA accelerator to allow the
CA to wick well into the wood of the fuselage and
wing. This will provide the best bond between the
two items.
4. Slide the wing back into position in the
fuselage. Check to make sure the wing is
perpendicular (90°) to the fuselage as shown.
Lightly sand the opening in the fuselage if
necessary to make any adjustments.
To Next Page
Loading...
