4. Slide the hinges and elevator into position
on the stabilizer. Align the end of the elevator
with the end of the stabilizer. Remove the
T-pins to position the elevator as close to the
stabilizer as possible, eliminating the gap
between the two. Saturate each hinge, top
and bottom, with thin CA.
Note: Do not use CA accelerator on the
hinges. The CA must be allowed to soak into
the hinges and surrounding wood to provide
the best bond.
5. Repeat Steps 2 through 4 to install the
remaining elevator. Apply thin CA to the elevator
joiner as well as the hinges.
20
To Next Page
Loading...
