4. Slide the wheel assembly into the 7/64"
hole in the landing gear, making sure the
wheel will be on the correct side of the
gear. Use a 3/32" hex wrench in the screw to
prevent it from rotating while installing the
4-40 nut on the inside of the landing gear.
Use a drop of thin CA or threadlock on the
nut to prevent it from vibrating loose.
5. Repeat Steps 3 and 4 for the remaining wheel.
6. Attach the main gear to the fuselage using two
2mm x 15mm machine screws and the two 2mm
nuts. Use a drop of thin CA or threadlock on the
nuts to prevent them from vibrating loose.
24
To Next Page
Loading...
