10. With the radio system on, attach the servo
horn to the aileron servo.
11. Attach a nylon clevis to the outer hole
of the control horn. Slide the short 5
1
/2"
(140mm) pushrod through the connector
on the servo, then into the nylon clevis.
The pushrod should protrude about 1/16"
(1.5mm) into the forks of the clevis. Use a
couple drops of thin CA to glue the clevis to
the pushrod. Be careful not to accidentally
glue the clevis to the control horn.
30
To Next Page
Loading...
