8.0 Lithium Battery Replacement Instructions (Continued)
Step 1 : Disconnect power from the
E-Mon D-Mon®
Green Class Net Meter at
the unit external circuit breaker.
Step 2 : Remove the battery from its socket and place on a non-conductive
surface.
Step 3: Install new battery into the PCB Battery socket
NOTE: The Main Power Board Battery socket is keyed to prevent user from
inserting the new battery in the wrong polarity. No damage to
unit or battery will occur if battery is inadvertently installed in wrong
direction.
Step 4: Visually inspect new battery to verify that all leads are fully inserted
into their respective socket positions.
Step 5: Dispose of the used battery in accordance with the manufacturers’
(Eagle Picher) instructions.
Page 19
To Next Page
Loading...
