Master/Global 69
• Same Bank: Copies the banks into the same numbered bank
locations on the destination disk.
• Empty Bank: Copies the banks into the lowest consecutive empty
bank locations on the destination disk.
10. Select the bank destination and press ENTER. The display will
inquire if you are sure. Press Yes if you are, and backup will proceed.
Press No to cancel the operation and return to the Module Identifier.
During the Backup procedure, the display will show the banks being
copied.
To Restore:
To restore your backed-up disk, simply reverse the source and destina-
tion drives following the directions for backup.
8. Floppy Save to Version 1.04
This submodule allows you to save a bank to a floppy disk in the older
software version 1.04. This function could be useful if you wanted to
transfer sounds to an older, non-updated ESI-32. To save a bank in the
older format, simply insert a blank formatted floppy disk (any version)
and press ENTER to save. The display will prompt you to insert addi-
tional disks if necessary.
! Caution:
You cannot load individual
presets and samples from floppy disks
saved in version 1.04 software.
To Next Page
Loading...
