214 ESI-32 Operation Manual
Troubleshooting
This section explains some of the problems you might possibly encoun-
ter while working with the ESI-32. Before assuming that your ESI-32 is
faulty, check the following list which details the corrective action you
can take yourself without having to call a service center. If you have any
doubts or questions, get in touch with your nearest E-mu dealer or call
the E-mu customer service department at (408) 438-1921, between the
hours of 8:30 am and 5:30 pm Monday through Friday.
The ESI-32 seems dead
If the ESI-32 seems dead, first disconnect any external SCSI devices and
try again.
Problem: The unit is completely dead. No lights no sound.
Cause: The power supply may be damaged.
Solution: Consult your dealer or authorized E-mu service center.
Audio Problems
Problem: The ESI-32 powers up normally, but does not make any
sound.
Cause: Proper audio connections may not have been made.
Solution: Try listening directly to the stereo output using head-
phones to verify that the ESI-32 is at fault. Check that
proper audio connections have been made.
Problem: The ESI-32 powers up normally, but does not make any
sound.
Cause: The front panel volume control may need recalibration.
Solution: Recalibrate the volume control using the Recalibrate
function located under Special in the Master/Global
module.
Problem: The ESI-32 powers up normally, but does not make any
sound.
Cause: Proper MIDI connections may not have been made.
Solution: Try using the trigger buttons to play the ESI. Check
MIDI activity LED. Verify that proper MIDI connections
have been made.
Problem: The digital audio output level is too low when a single
channel is played.
Cause: Because of the nature of sampling instruments, each
additional channel played adds +3 dB to the headroom
requirement. A single channel on the ESI-32 comes out
about -6 dB down.
Solution: Make sure the Master Volume control is at maximum.
Set the headroom adjustment (Master/Global, Special, 3)
to 0 dB. All volume adjustments in the ESI-32 affect the
digital output level.
To Next Page
Loading...
