CLEANING WARNING
Make sure that the Balance Bike is in the "parking"
position (kickstand in the open position, on a flat, sloping
or uneven surface), that the charger is unplugged and that
the Balance Bike is off (off). Make sure that the charging
port is protected by the rubber plug, to avoid damaging
the device by introducing water.
WARNING BRAKES
Make sure that the Balance Bike is in the "parking"
position (kickstand in the open position, on a flat, sloping
or uneven surface), that the charger is unplugged and that
the Balance Bike is OFF (off).
Please check the brakes before use. Pay attention to the
brake voltage and use the supplied key if they are too
loose or too tight.
4) Cleaning / Maintenance / Repairs
a) Cleaning
- Clean with a damp cloth to remove dust and dirt.
- Do not use industrial cleaners or solvents as this may
damage the surfaces.
- Do not use alcohol or ammonia-based cleaners as this may
damage the components.
b) Brakes: maintenance / adjustments
i) Adjustment of brake cable tension
The manipulations are identical for the front and rear brakes.
To tighten or loosen the brakes use the supplied wrench,
unscrew the nuts on the cables placed on the brake shoes and
pull the cable slightly to shorten or lengthen it according to the
desired action:
To Next Page
Loading...