E-stim 2B - Modes; Selecting a Mode

Modes
The 2B has two sets of modes. Program modes offer variations on output and are of
most interest to the user. System Modes control the general operation of the 2B.
Selecting a Mode
The 2B has a very simple method of selecting
a mode. Simply double press the SELECT
button, to place the 2B into mode select and
then twist the ADJUST knob to change mode
up and down. When the 2B is in mode select
the outputs are automatically disabled.
1
P
u
l
s
e
U
s
e
A
D
J
U
S
T
t
o
c
h
In addition the mode select screen also gives you advice on how to do this via a
scrolling message.
Use the ADJUST control to cycle through the available modes. Once you have found
the mode you want press the SELECT button to activate. The modes are
1. Pulse
2. Bounce
3. Continuous
4. A Split
5. B Split
6. Wave
7. Waterfall
8. Squeeze
9. Milk
10. Throb
11. Thrust
12. Random
13. Step
14. Training
15. Microphone
16. Stereo
17. Tickle
The following are system modes and as such, they are used to change and view the
system options of the 2B.
18. Power Level
19. AB Join
20. Backlight
21. Factory Reset
22. Commander
If you need to shutdown the
outputs quickly, just press the
select button twice. The outputs
will be reset to OFF.
Remember when you select a
new mode, you generally have
to turn the outputs on to get any
response from the channel
outputs. All modes default to
OFF when first selected..
13