E-stim 2B - Training Mode; Tickle Mode

Training Mode
T
r
a
i
n
i
n
g
3
4
:
5
0
A
:
1
0
%
L
B
:
7
9
%
The training mode is similar to the Step Mode (page 18), but the steps are much bigger,
requiring the subject to learn to ‘enjoy’ each step before the output is stepped up to
the next level.
The output steps between 0 and the current Channel level. Each step is 1/12 of the
total Channel level or 1% if the channel level is set to 12% or lower, so if Channel A is set
to 48%, the steps will be 4%, 8%, 12% up to 48%, and then dropping to zero. The Adjust
value allows you to adjust the delay between level changes, from 2 to 100. The second
value, is the pulse feel, that allows you to adjust the sensation of the pulse stream, from
soft to spiky.
Lower values, give a faster step.
Because of the delay of the programmed step, any changes in output level, will only
occur at the next step change.
Tickle Mode
T
i
c
k
l
e
5
0
A
:
1
0
%
L
B
:
1
0
%
A continuous mode, that is only active when the adjustment knob is being turned,
giving an effect similar to being tickled…hence the name. Turn the adjustment knob
faster for a more pronounced tickle. Note the output is only active then the level
controls are set above 0%.
Tickle mode is not accessible from Commander.
19