E-XTEQ DCBS - Page 16

16/52
DCBS User Manual / Ref. MAN_DCBS_GM_EN_V1.0
Initial Setup 7/8
UPDATE ////////
The update
will progress and the
yellow bar will appear
signaling to don’t
disconnect the device
during this step.
When the update is
nished, please click the
eject button to be able
to get out of the USB
connecting mode.
TROLLEY UPDATE
When connected to the trolley, DCBS Remote might detect that an update is needed
for the trolley.
The following message will then appear.
You will need to connect the trolley to your computer to update via USB cable.
Table of Content
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Getting Started
Safety Reminders
Appearance and Dimensions
Trolley LED’s
Remote Presentation
Remote Job Storage
Accessories
Initial Setup
Installation
Battery Cable Clamps Connection
Power Cable Connection and Power On
Dealer Id. N°
Wi-Fi Connection (Remote to Trolley)
Physical Connection (Remote to Trolley)
Update
Settings
Preferences
Other Settings
Diagnostic and Charge
Remote handheld diagnostic tester
-Manual Selection of Battery
-Vehicle Selection from Database
-Start Diagnostic & Results
Trolley Diagnostic
-Complete Diagnostic & Results
-Pre Delivery Inspection Test (PDI) & Results
-Charge & Results
-Load Test & Results
-Enhanced Diagnostic Mode (EDM) & Results
-Reserve Capacity Test & Results
History (Results Storage)
Optimus
-Optimus Installation
-Using Optimus
Support Information
-Batteries
-Error Messages
Warranty