Need help?Do you have a question about the Eagle 800 and is the answer not in the manual?
General| Model | Eagle 800 |
|---|---|
| Category | Packaging Equipment |
| Material | Stainless Steel |
| Control System | PLC with Touch Screen Interface |
| Type | Flow Wrapper |
| Film Width | 800 mm |
| Product Height | 150 mm |
| Maximum Speed | 150 packages per minute |
| Power Requirements | 220V, 50Hz, 3kW |
Guidelines for safe operation, including electrical connections and body placement.
Specifies ideal location conditions, free from smoke, corrosive materials, and excess moisture.
Instructions for safely moving the machine using forklifts or tow motors with locked wheels.
Defines the correct standing position and required clearance for the operator during use.
Details the purpose and operation of each button and indicator on the control panel.
Step-by-step guide on how to load and feed the strapping material into the machine.
Describes the sequence of connecting power, setting modes, and placing packages for strapping.
Highlights the importance of regular maintenance for extending machine lifespan and ensuring smooth operation.
Specifies parts requiring regular lubrication with N68 oil for trouble-free operation.
Instructs to check the oil reservoir level for the decelerator to ensure optimal performance.
Emphasizes periodic checks of proximity switch sensitivity and alignment for efficiency.
Details adjustments for crown bar, pry bar, motor, and brake gaps for proper strap feeding.
Guides on adjusting feed time, unthreading time, spacing time, and temperature settings.
Addresses problems like strap not adhering or feeding properly and their potential causes.
A table listing frequently replaced components with their descriptions and notes.
Illustration and parts list for the slide assembly, including rails and plate.
Illustration and parts list for the top body assembly, including plates and partition boards.
Illustration and parts list for the left top knife assembly, including jack catch and springs.
Illustration and parts list for the middle top knife assembly, including springs and seat board.
Illustration and parts list for the right top knife assembly, including jack catch and springs.
Illustration and parts list for the spindle assembly, showing main spindle and cams.
Illustration and parts list for the heating body assembly, including bracket and guide plate.
Illustration and parts list for heating section and slide plate components, including covers and sleeves.
Illustration and parts list for the heating section assembly, including insulation board and base plate.
Illustration and parts list for the strapping force assembly, including knob, bracket, and gear.
Illustration and parts list for the strapping pendulum bar, including tension bar and bearings.
Illustration and parts list for the pre-strap feeding mechanism, including wheels, axles, and bearings.
Illustration and parts list for the pendulum mechanism, including roller wheel and swing block.
To Next Page