85
Sonar Simulator
This unit has a built-in simulator that lets you run it as if you were on
the water. All sonar features and functions are useable. When in
simulator mode, you will occasionally see the word Simulated in the
Sonar Page at the bottom of the screen. To use the simulator:
1. From the Sonar Page, press
MENU|MENU|↓ to SONAR SIMULATOR|ENT.
2. Turn off Sonar Simulator by pressing
MENU|MENU|↓ to SONAR
SIMULATOR|ENT|EXIT.
NOTE:
If you turn on your unit before attaching a transducer, it may enter
a demo mode. The words "demo mode" flash on the bottom of the
screen and a sonar chart plays much like the simulator. Unlike the
simulator, the demo mode is for demonstration only, and will auto-
matically stop as soon as you turn on the unit with a transducer at-
tached. The simulator will continue to function normally.
Stop Chart
If you are running multiple units on a boat, there are times when you
may want to turn off the sonar. This command turns off the sonar and
stops the chart from scrolling. Sonar restarts automatically each time
you turn on your unit.
Press
MENU|↓ to STOP CHART|ENT|EXIT.
To turn on sonar and start the chart scrolling again, repeat the above step.
To Next Page
Loading...
Need help?
General