- To DISARM the system :
To disarm your system within proper operating range, simply press button once (while
system in arm position). The system will respond two siren chirp, two light flash, doors unlock,
Enable your engine starter, LED off.
- Intrusion Alert:
Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will Indicates
5 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following
different triggering.
flash 2 times after a pause Sensor 1st-stage tri ggered
flash 3 times after a pause Sensor 2nd-stage triggered
flash 4 times after a pause D oor switch triggered
flash 5 times after a pause Trunk switch triggered
flash 6 times after a pause Hood switch tri ggered
Flash 7times after a pause Ignition switch triggered
- 2-way LCD Intrusion Alert:
Upon disarming the system, if the vehicle is attempted or intruded, the 2-way remote will respond
2 short beep follow with melody sound, and LCD display will indicates different icons as under:
Zone1:1st-stage
sensor triggered
Zone1:2nd-stage
sensor triggered
Door switch
triggered
Trunk switch
triggered
Hood switch
triggered
Ignition switch
triggered
Note: Before the ignition turn on, you may realized again which zone been triggered by press
button (status check) once, the LCD will display triggered zone again.
2-way LCD display :
+ Two beep sound
Zone2: 1st-stage
sensor triggered
Zone2: 2nd-stage
sensor triggered