Commercial Broadcast Spreader
with Side Spread Control
MODEL # 2170 ASSEMBLY INSTRUCTIONS
P2170_M52164_Rev_May2020_compressed PAGE 1
Prior to assembly, you will
need the following tools:
Needle nose pliers
#2 Phillips screwdriver
Adjustable wrench or ½” box
wrench
7/16″ wrench
SIDE SPREAD CONTROL
Your EarthWay spreader includes a feature called side
spread control. This feature turns off fertilizer from being
spread to the left side. To activate this feature, slide the
lever below the hopper to the right (if standing behind
the spreader) and walk along a sidewalk or flowerbed
that is 12″-14″ on your left side. Fertilizer will not spread
to the left. This feature is better than a deflector as no
material is wasted by the deflector.
ASSEMBLY HARDWARE
SPREADER COMPONENTS
To Next Page
Need help?
General
