Need help?Do you have a question about the East 10KVA and is the answer not in the manual?
Provides detailed technical specifications across various UPS models.
General installation steps and methods for qualified personnel.
Details wiring requirements, cable dimensions, and terminal block connections.
Steps for installing parallel UPS units, including signal and power cable connections.
Details how to configure various UPS settings like voltage, frequency, and address.
Instructions for setting the UPS output voltage to 220V, 230V, or 240V.
Step-by-step guide for safely starting the UPS and ensuring normal operation.
Procedures for entering and exiting maintenance bypass mode for servicing.
Detailed steps to shut down the UPS and disconnect all loads.
How to use the EPO function to immediately shut down the UPS in emergencies.
Steps to reset the UPS after fault conditions and restore normal operation.
Describes fault conditions, LED indications, and actions to take during UPS faults.
Safety precautions and procedures for maintaining UPS storage batteries.
Critical safety instructions to follow before, during, and after UPS maintenance procedures.
General| Communication Interface | RS232, USB, SNMP (Optional) |
|---|---|
| Frequency | 50/60Hz |
| Battery Type | Sealed Lead-Acid (SLA) |
| Efficiency | >90% |
| Operating Temperature | 0°C to 40°C |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Protection | Overload, Short Circuit, Over Temperature |
| Capacity | 10KVA / 9KW |
| Battery Backup Time | Typically 5-15 minutes at full load (depending on battery configuration) |
To Next Page
