Need help?Do you have a question about the East 30KVA and is the answer not in the manual?
Provides general safety guidelines for UPS usage and battery handling.
Details critical warnings and cautions for safe operation and maintenance.
Introduction to general installation steps and methods for qualified personnel.
Specifies ideal conditions and location requirements for UPS installation.
Details wiring requirements, cable dimensions, and screw dimensions for UPS connection.
Step-by-step guide for connecting power cords for single wiring installation.
Details connecting signal cables for parallel UPS units.
Details connecting power cables for parallel UPS units.
Explains how to access and modify UPS parameters and settings.
Details the procedure for setting the UPS output voltage.
Details the procedure for setting the UPS output frequency.
Details the procedure for configuring the manual bypass function.
Provides step-by-step instructions for starting up the UPS.
Outlines steps to completely shut down the UPS and disconnect loads.
Explains how to use the EPO port for emergency shutdown.
Steps to recover normal operation after a fault or alarm.
Describes indicators and conditions during UPS fault mode.
Faults for output short-circuit and bypass overload conditions.
Faults concerning inverter operation and model detection.
Safety precautions and procedures for maintaining UPS storage batteries.
Specific safety measures to follow during UPS maintenance.
To Next Page
General
