FG 32 DDC – pre release user guide – V1.4
4
Introduction
We are getting ready to release our new FG series of Controllers, starting with the EasyIOFG32 DDC
controller, product reference: EasyIO-FG-GC-32.
It is equipped with two 32-bit Processors, the first in the Automation industry, with an ARM9 200
MHz Samsung processor, an ARM M3 Cortex for the I/O management and A-D processing, and also
with a Linux 2.6 OS for premium performance. Later in 2013 we will be adding Graphics capability to
serve up html templates that will be stored on the Micro SD card. BACnet and Modbus will also be
added in 2013. TCOM is available now and is encouraged for premium performance with Niagara.
• The Build bootloader can now be carried out remotely. No more manual service button
needed is used.
• Firmware upgrading now can be done remotely and without any assistant.
• Firmware upgrading is via ftp client.
• In this user guide is just a pre-release internal use user guide.
Note: Information in this document is accurate at the time of documented. Actual information may
change/defer without notice.
This document in only intended for the beta testing process.
To Next Page
Loading...
