EasyIO FG32 - Sedona Workbench Connection; Install Platform and Kit Files

FG 32 DDC – pre release user guide – V1.4
9
Connecting to FG32 Sedona DDC via Sedona workbench
In order to connect to the new EasyIO FG32 DDC, some files are needed. EasyIO FG32 has a different
sedona platform, files and kits. These kits are hardware dependent.
Follow the below instructions before connecting to the controller via Sedona Workbench.
Install platform files and kits files
Step 1
Get the required files from easyIO technical support at support@easyio.com
Step 2
Close the workbench.
Open sedona folder in the Niagara installation directory;
Niagara Version
Sedona directory
Niagara Ax 3.5.xx
Niagara
\
niagara 3.5.xx
\
sedona
\
Niagara Ax 3.6.xx
Niagara
\
niagara 3.6.xx
\
sedonaBundles
\
sedona
1.1.xx\sedona\
Niagara Ax 3.7.xx
Niagara
\
niagara
3.7.xx
\
sedona
\
Step 3
Copy and merge the 2 folders that obtain from easyIO technical support.
The 2 folders are :platform and kits
For Niagara Ax 3.5 User go to step 4.
For Niagara Ax 3.6 User go to step 5.
For Niagara Ax 3.7User go to step 6.