FG 32 DDC – pre release user guide – V1.4
15
Restoring FG32 back to default apps
At the moment, there are 2 ways to restore the sedona apps for FG32 controller.
The first way is where you could still gain access to the controller via sedona workbench. By
manually selecting all the objects and delete it. The “SAVE” action is needed.
Then a reboot or restart of the VM will erase all the objects in the sedona apps.
The second way of restoring the FG32 back to default apps is via ftp client software. This way can be
use as well if the FG32 sedona VM is not connectable and the controller keep rebooting due to some
incompatible sedona apps loaded. When this happen, the watchdog will kick in and will not allow
the sedona VM to boot at all, hence a rebooting cycle will occur.
Note :
A easyIO 30P sedona apps CANNOT be loaded into the easyio FG32 as the sedona apps from a 30P
backup is hardware dependent. Doing so will corrupt the FG32 sedona VM and the controller will
keep rebooting the sedona VM, hence the controller is not accessible via Sedona Workbench.
If the rebooting cycle occurs, the status LED will blinks for fast for a few times then light up steady for
approx 10 seconds.
If the above note happen, follow the below steps to regain sedona connection. Below steps can be
use for restoring the FG32 to default apps as well.
Email to support@easyio.com to request for the FG32 default apps.
To Next Page
Loading...
